Get in Touch with SINOFUDE Company
Which Depositor Models Fit Your Building
Which Depositor Models Fit Your Building
The two constraints a capacity figure never surfaces are floor area and installed power. Enter the space and the supply you actually have, and this checks each of the five models against both.
What this does and does not decide
It compares your clear length, clear width and available power against the published footprint and installed power of each model.
It does not include the cooling tunnel run-out, the setting room, operator access aisles or the space a mould change needs, all of which are settled on a layout drawing rather than by a calculator.
Constraint Assumptions
Model assumption: a model fits when your length is at least its published length, your width is at least its published width, and your available power is at least its installed power. Footprints and installed power are taken from the model comparison table on the depositor page. No access margin is added.
Your Workshop Parameters
Evaluation Output
Enter your figures and press the button.
